ludzik
Lenfald
Lenfald Freeman
Posts: 1,047
|
Post by ludzik on Jan 19, 2016 13:29:59 GMT -8
I ended up picking up for pretty cheap 10676 which has a big front gate type panel. Panel in itself would not be exciting if it wasn't for the fact that it's setup for doors but there are no doors in the set. I did a search on Bricklink for Panel 4 x 16 x 10 to catch other "print" variations and found a total of 4 (one of them being the one that I owned). Unfortunately in none of the sets there were doors included which brings me to my dilemma - which doors would fit? I'm looking through list of doors on bricklink and getting a headache... Does anyone have any ideas? below is a link to the Panel search results www.bricklink.com/catalogList.asp?q=Panel%204%20x%2016%20x%2010
|
|
|
Post by dzidek1983 on Jan 26, 2016 3:03:34 GMT -8
You need at least a 4 wide and ca 8 high curved door panel for this. Only thing that could fit is this: alpha.bricklink.com/pages/clone/catalogitem.page?P=6105#T=C I dont know if the curve will fit perfectly with the gateway curve. Also you wont be able to open the door to the outside. There are 2 strig holders on the gateway that prevent this.
|
|
ludzik
Lenfald
Lenfald Freeman
Posts: 1,047
|
Post by ludzik on Jan 26, 2016 14:29:43 GMT -8
I don't think that those doors will work as the notches are in the wrong spots.
|
|
|
Post by dzidek1983 on Jan 26, 2016 23:40:45 GMT -8
|
|